ADTRAN IQ 710 System Manual page 265

Huntsville IQ 710 (DCLI 400)
1. Using the left arrow, place the cursor over the number 1 (indicating entry 1) to the left of the DLCI
field; then press
2. Now add the DLCI to the Birmingham site. Use the right arrow to select DLCI; then press
Type in 400 and press
3. Use the right arrow to select DBU DLCI; then press
Notice that the TELCO-assigned DLCI of 400 for Huntsville's Frame Relay link to Birmingham is
programmed in the DLCI field. The TELCO-assigned DLCI of 300 for Birmingham 's Frame
Relay link to Huntsville is programmed in the DBU DLCI field. These two entries are critical for
proper dial backup operation.
4. Use the right arrow to select DBU PHONE NUMBER; then press
and press
<Enter>
IQ 710 to establish a dial backup connection has now been programmed.
5. Use the right arrow to select C
the table to be prioritized in the event that multiple PVCs are lost at once. Dial backup will first be
attempted on the PVC with the lowest Call Order that meets the DBU Criteria settings. Set this
Call Order to 3.
6. Use the right arrow to select DBU O
E ; then press
NABLED
© 2002 ADTRAN, Inc.
for insert. This should add an entry as shown in Figure 24.
<I>
Figure 24. New Entry Screen
.
<Enter>
. The phone number that the Huntsville IQ 710 will dial to reach the
O
ALL RDER
I
N NACTIVE
.
<Enter>
. Type in 300 and press
<Enter>
. DBU C
N O
UMBER ALL RDER
; then press
<Enter>
61202800L1-1B
Section 6, Configuration Guides
Page 265
<Enter>
. Type in 12055553000
<Enter>
Birmingham
allows each DLCI listed in
. Down arrow to select
IQ 710 System Manual
IQ 710
.
<Enter>
.