ADTRAN IQ 710 System Manual page 206

61202800L1-1B
IQ 710
Section 6, Configuration Guides
Page 206
The Huntsville Unit will have 23 entries in its PVC configuration table to correspond to the 23
remote sites.
4. For the first entry, use the right arrow to select DLCI; then press
.
<Enter>
5. Use the right arrow to select DBU DLCI; then press
Notice that the TELCO-assigned DLCI of 16 for Huntsville's Frame Relay link to Atlanta is pro-
grammed in the
Huntsville is programmed in the
backup operation.
6. Use the right arrow to select DBU P
press . The phone number that the Huntsville IQ 710 will dial to reach the Atlanta IQ 710 to
<Enter>
establish a dial backup connection has now been programmed.
7. Use the right arrow to select DBU O
8. Down arrow to select E
the IQ 710 in Atlanta in the event that DLCI 16 is advertised as Inactive by the Frame Relay switch.
At this point all PVC options have been configured for basic Frame Relay dial backup to Atlanta.
The PVC entry for DLCI 16 on the Huntsville IQ 710 should look like the screen shown in Figure
16. The remaining options may be left at their default values. The
D M
ELAY EASUREMENT
tion of these features please refer to the IQ 710 User Manual.
IQ 710 System Manual
DLCI field. The TELCO-assigned DLCI of 20 for Atlanta's Frame Relay link to
DBU DLCI
HONE
I
N NACTIVE
; then press
NABLED
, and
STATS O
PTION
<Enter>
. Type in 20 and press
<Enter>
field. These two entries are critical for proper dial
N ; then press
<Enter>
UMBER
; then press
<Enter>
. This allows the Huntsville IQ 710 to dial out to
<Enter>
are features not related to dial backup. For an explana-
. Type in 16 and press
<Enter>
. Type in 12565552000 and
.
CIR , S N C
EQ UM HECKING
© 2002 ADTRAN, Inc.
.
,