ADTRAN IQ 710 System Manual page 56

61202800L1-1B
IQ 710
Section 4, User Interface Guide
Page 56
Select which type of telco switch is providing the ISDN service. This information is
S T -
WITCH YPE
available from your service provider.
Choices: L
UCENT
Enter the LDN for this location. This information is available from your service provider.
LDN -
C >D
ONFIGURATION IAL
These options are only available with a DCE DBU card installed.
Select the connector type for the
I T -
NTERFACE YPE
Choices: EIA-232; V.35.
DBU B R (K
IT ATE BPS
Choices: 0 to 1536 kbps.
C >B
ONFIGURATION AUD
This field allows the user to select the baud rate of the Craft/Control port. This option is only available on
the front panel interface.
Choices:
9600, 19.2K, 38.4K,
C >S
ONFIGURATION YSTEM
Enter a new password of ten characters or less. The default password is adtran (not available on front
panel).
C >S
ONFIGURATION YSTEM
Enter the IQ 710 IP (internet protocol) address.
C >S
ONFIGURATION YSTEM
Enter the subnet mask assigned to the LAN that the ethernet port is attached to.
C >S
ONFIGURATION YSTEM
Enter the IP address of the Gateway. The Gateway IP address is used when an ethernet packet is transmit-
ted from the IQ 710 to a different subnet.
C >S
ONFIGURATION YSTEM
Enter the authentication strings used for SNMP management. Match the IQ 710 to the SNMP manager for
read privileges.
C >S
ONFIGURATION YSTEM
Enter the authentication strings used for SNMP management. Match the IQ 710 to the SNMP manager for
write privileges.
IQ 710 System Manual
5ESS, DMS 100, N
ATIONAL
B >DCE O
ACKUP PTIONS
Set to the operating speed of the
) -
R
ATE
and .
57.6K
>P
ASSWORD
>IP A
DDRESS
>S M
UBNET ASK
>G IP A
ATEWAY
>R C
EAD OMMUNITY
>W C
RITE OMMUNITY
.
interface.
DCE
interface.
DBU
DDR
© 2002 ADTRAN, Inc.