ADTRAN IQ 710 System Manual page 154

61202800L1-1B
IQ 710
Section 6, Configuration Guides
Page 154
DBU Criteria
1. From the screen shown in Figure 6, press the down arrow to select DBU C
screen shown in Figure 7 is displayed. The default values for the parameters on this screen are
shown.
2. Use the right arrow to select W
select E ; then press
NABLE
network T1 line goes into alarm.
is enabled by default. With this option enabled, the IQ 710 unit will go into dial
W N LMI
ITH O
backup when the
3. Press the down arrow to select W
select E ; then press
NABLE
This is a global setting that affects all of the PVCs in the IQ 710 DLCI table (under
). A PVC is advertised as Inactive by the frame switch in the CO when there is a problem
O
PTIONS
at the remote end of the frame circuit. With this option enabled, the IQ 710 will attempt to estab-
lish a dial backup call with the remote unit when its corresponding DLCI is advertised as Inactive
(provided that DLCI does not have
Once these parameters have been configured properly, the
exactly like Figure 8.
IQ 710 System Manual
Figure 7. DBU Criteria Menu
N
ITH ETWORK
. This allows the IQ unit to enter dial backup in the event that the
<Enter>
F R S
RAME ELAY IGNALING
PVC I
ITH
.
<Enter>
DBU O
F ; then press
<Enter>
AILURE
is down.
S
TATE
; then press
<Enter>
NACTIVE
disabled under the
I
N NACTIVE
DBU C
RITERIA
. The menu
RITERIA
. Use the down arrow to
. Use the down arrow to
N PVC
ETWORK
options).
N PVC
ETWORK
screen should look
© 2002 ADTRAN, Inc.