ADTRAN IQ 710 System Manual page 202

61202800L1-1B
IQ 710
Section 6, Configuration Guides
Page 202
3. Use the right arrow to select L
appear. Use the arrow keys to select the line code that matches the line code on the TELCO-pro-
vided PRI line; then press
4. Down arrow to select C
appear. Use the arrow keys to select N
Select I
NTERNAL
clock.
5. Down arrow to select L
will appear. The LBO should be selected based on the strength of the receive signal. Use the
arrow keys to select the correct value; press
6. Down arrow to select RX G
The N setting is adequate for most applications. If the receive signal strength is less than 30
ORMAL
dB, choose E
XTENDED
7. Down arrow to select S
for the TELCO-provided PRI line. If a full PRI circuit was purchased, the start channel will be one.
If a fractional PRI circuit was purchased, the start channel information can be obtained from the
TELCO.
8. Use the down arrow to select N
of channels for the TELCO-provided PRI line. If a full T1 circuit was purchased, the number of
channels will be 23. The D-channel, which is used for call signaling, always resides on channel 24.
If a fractional PRI circuit was purchased, the number of channels can be obtained from the
TELCO.
IQ 710 System Manual
Figure 11. Physical Layer Options Menu
C ; then press
INE ODE
.
<Enter>
S ; then press
LOCK OURCE
ETWORK
if there is no timing on the PRI circuit and the IQ 710 will have to provide the
B O (LBO); then press
INE UILD UT
; then press
AIN
.
C ; then press
TART HANNEL
UMBER OF
. Choices of B8ZS and AMI will
<Enter>
. Choices of I
<Enter>
if the TELCO is providing clocking on the PRI line.
. Choices of 0, 7.5, 15, and 22.5
<Enter>
.
<Enter>
. Choices of N
<Enter>
ORMAL
. Enter the first DS0 number available
<Enter>
C ; then press
<Enter>
HANNELS
and N
NTERNAL ETWORK
and E will appear.
XTENDED
. Enter the total number
© 2002 ADTRAN, Inc.
will