ADTRAN IQ 710 System Manual page 167

Birmingham IQ 710 (DLCI 20)
1. From the C
ONFIGURE
then press
<Enter>
munication with Huntsville.
2. Use the right arrow to select DBU DLCI; then press
note that this is the DLCI that the Huntsville IQ 710 uses to communicate with Birmingham.
3. Use the right arrow to select DBU P
press . The phone number that the Birmingham IQ 710 will dial to reach the Huntsville
<Enter>
IQ 710 to establish a dial backup connection has now been programmed.
4. Use the right arrow to select DBU
then press
<Enter>
event that DLCI 20 is advertised as Inactive by the Frame Relay switch.
Since there is only one PVC for Birmingham, there is no need to enter another entry into the PVC
table. At this point the Birmingham IQ 710 is configured for basic dial backup to Huntsville. The
C PVC O
ONFIGURE
by placing the cursor over the number 1 (indicating entry 1) to the left of the
ing .
<Enter>
© 2002 ADTRAN, Inc.
Figure 21. Atlanta IQ 710 (DLCI 20) Screen
PVC O screen shown in Figure 17, use the right arrow to select DLCI;
PTIONS
. Type in 20 and press
<Enter>
HONE
I
ON NACTIVE
. This allows the Birmingham IQ 710 to dial out to the IQ 710 in Huntsville in the
screen is shown in Figure 22. The vertical screen shown can be achieved
PTIONS
. This is the DLCI that Birmingham uses for com-
. Type in 17 and press
<Enter>
N ; then press
<Enter>
UMBER
; then press
<Enter>
61202800L1-1B
Section 6, Configuration Guides
Page 167
<Enter>
. Type in 12565551000 and
. Down arrow to select E
DLCI field and press-
IQ 710 System Manual
IQ 710
. Please
;
NABLED