ADTRAN IQ 710 System Manual page 118

61202800L1-1B
IQ 710
Section 5, Detail Level Procedures
Page 118
Front Panel Configuration
Enter the IP Address:
1. From the front panel, press 1 for C
2. Press 6 for S
YSTEM
3. The cursor will now be blinking on 1 for IP A
A and press <Enter>.
DDRESS
4. Press 2 for S
UBNET
<Enter>.
5. Press 3 for GW IP A
and press <Enter>.
Enter the Management DLCI:
1. Cancel back to the Main menu.
2. Press 1 for C
ONFIG
3. Press 2 for N
ETWORK
4. Press 3 for DLCI 1 and press <Enter>. Enter the appropriate DLCI and press <Enter>.
5. If more than one management DLCI is being used, press 4 for DLCI 2 and press <Enter>. Enter
the appropriate DLCI and press <Enter>.
Enter the Management DLCI Mode:
1. Press 5 for DLCI 1 M
used to carry customer traffic as well as management data, and press <Enter>.
2. If more than one management DLCI is being used, press 6 for DLCI 2 M
Use the arrow keys to select S
agement data, and press <Enter>.
The IQ 710 supports management from two network DLCIs either shared or dedicated.
The IQ 710 can simultaneously support management on two DLCIs. The unit will support
both DLCIs set to
one to
D
IQ 710 System Manual
ONFIG
and press <Enter>.
M and press <Enter>. Enter the appropriate S
ASK
option and press <Enter>. Enter the appropriate Gateway IP address
DDRESS
and press <Enter>.
P and press <Enter>.
ORT
and press <Enter>. Use the arrow keys to select S
ODE
if the DLCI is used to carry customer traffic as well as man-
HARED
, both DLCIs set to
S
HARED
.
EDICATED
and press <Enter>.
. Press <Enter>. Enter the appropriate IP
DDRESS
, or one DLCI set to
D
EDICATED
M and press
UBNET ASK
if the DLCI is
HARED
and press <Enter>.
ODE
and
S
HARED
© 2002 ADTRAN, Inc.