UPDATING THE FIRMWARE OF AN IQ 710 USING XMODEM
Introduction
The IQ 710 supports firmware updates via the
C
/C
port using XMODEM. This procedure outlines the steps for a successful firmware
RAFT
ONTROL
upgrade using the
C
RAFT
Tools and Materials Required
•
VT-100 terminal or PC with VT-100 terminal emulation software
•
XMODEM software
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
Electronic modules can be damaged by static electrical discharge. Before handling
modules, wear an antistatic discharge wrist strap to prevent damage to electronic
components. Place modules in antistatic packing material when transporting or storing.
When working on modules, always place them on an approved antistatic mat that is
electrically grounded.
© 2002 ADTRAN, Inc.
E
THERNET
/C
port and XMODEM software.
ONTROL
Section 5, Detail Level Procedures
port using TFTP from a network server or via the
61202800L1-1B
IQ 710
Page 103
IQ 710 System Manual