Chapter 6. Configuring DTE Options
Auxiliary Port
The A
the secondary channel if the secondary channel option was selected
during setup of the N
DTE options menu, press
submenu and press
The A
secondary channel speed is higher than the throughput in the
network, CTS flow control is activated. If the secondary DTE does
not respond to CTS flow control, care should be taken to prevent
the A
A
access through the EIA-232 interface. For more details on this
option, refer to VT-100 Connection on page 4-5.
1= LOCAL
3= CONFIG
2= REMOTE ENTER ADDRESS
6-16
P
option is used to select the operating speed for
UXILIARY
ORT
ETWORK
Enter
P
has an internal 256 byte buffer. If the
UXILIARY
ORT
internal buffer from overflowing. The
P
UXILIARY
ORT
P
option may also be used to provide VT-100 menu
UXILIARY
ORT
1= NETWORK OPT.
2= DTE OPTIONS
3= TEST OPTIONS
4= DIAL OPTIONS
5= MANUAL COM.
DSU III AR User Manual
O
(see Figure 6-12). From the
PTIONS
to activate the A
Shift + B
to select. The factory default is O
1= DTE RATE
2= CONNECTOR TYPE
3= DATA FORMAT
4= DTE CMD OPTION
5= TRANSMIT CLOCK
6= CS OPTIONS
7= ANTI-STREAM
8=CD OPTIONS
9=TR OPTIONS
A= SR OPTIONS
B= AUXILIARY PORT
Figure 6-12. Setting the Secondary Rate
P
UXILIARY
ORT
.
FF
1= 1.2K AT_CMD
2= 75 SEC
3= 150 SEC
4= 300 SEC
5= 600 SEC
6= 1.2K SEC
7= 2.4K SEC
8= OFF
9= 300 CONTROL
A= 1.2K CONTROL
B= 2.4K CONTROL
C= 9.6K CONTROL
61202011L1-1