Replacing Labels - Siemens SIMATIC Distributed I/O ET 200eco PN Operating Instructions Manual

Installing

2.5 Replacing labels

connector and that it is mounted onto connector X02 of the I/O device. Bolt the terminal
block onto the I/O device by tightening the screws.
Figure 2-6 Installing the terminal block on an I/O device of 60 mm width
See also
Wiring the terminal block (Page 56)
Terminal block and voltage distributor (Page 221)
2.5 Replacing labels
Properties
You can identify the I/O device and the I/O connectors using the labels. The module is
supplied with the labels already clipped into the holder.
• 1 for the I/O device
• 4 or 8 for the I/O connectors
Requirements
You can order replacement labels.
Tools required
2.5 to 4 mm slotted screwdriver
26
Operating Instructions, 06/2022, A5E01250250-AN
ET 200eco PN