Configuring An Io-Link Master; Configuring The Io-Link Master 6Es7148-6Ja00-0Ab0 - Siemens SIMATIC Distributed I/O ET 200eco PN Operating Instructions Manual

Configuring

4.2 Configuring an IO-Link master

4.2 Configuring an IO-Link master
4.2.1

Configuring the IO-Link Master 6ES7148-6JA00-0AB0

Requirements
Configuration of the IO-Link Master takes place in two steps:
1. You need STEP 7 as of version V5.4 + SP5 + HSP188 for the IO-Link Master.
2. Configure the connected IO-Link Devices, encoders, and actuators with the Port
Configurator tool (S7-PCT).
Configuring the IO-Link Master with HW ConfigHW Config
1. Start the SIMATIC Manager and configure the project as described in the STEP 7 online
help.
2. Drag the IO-Link Master from the HW catalog PROFINET IO > ET 200eco PN > IO Link > 4
IO-L + 8 DI + 4 DO DC24V/1.3A 8×M12 V6.1.
You can freely choose the address space in the Properties > Addresses field for each slot
of the IO-Link Master. Additional information on possible configurations is available in the
chapter I/O address space (Page 251).
3. Assign the IO-Link Master parameters. You can assign the parameters separately for each
functional unit:
– The PROFINET IO parameters are accessed by double-clicking Slot 0.
– The IO-Link parameters are accessed by double-clicking Slot 1.
– The 8 digital input and 4 digital output parameters are accessed by double-clicking Slot
Configuring the IO-Link Devices using "Configure IO-Link"
1. Select Slot 1 "4 IO-L" from the configuration table of the I/O device IO-Link Master.
2. Right-click and select "Configure IO-Link" in the following shortcut menu.
Result: S7-PCT is started.
3. Now start with the parameter assignment of the IO-Link Devices, sensors, and actuators.
You can find additional information in the S7-PCT online help.
64
2.
Operating Instructions, 06/2022, A5E01250250-AN
ET 200eco PN