Siemens SIMATIC Distributed I/O ET 200eco PN Operating Instructions Manual page 4

Preface
Purpose of the manual
The information in this manual enables you to run the ET 200eco PN distributed I/O device on
PROFINET IO as IO device.
Basic knowledge required
This manual presumes a general knowledge in the field of automation engineering.
The manual describes the components based on the data valid at the time of its release.
SIEMENS reserves the right of including a product information for each new component, and
for each component of a later version.
Scope of this manual
This manual applies to the ET 200eco PN distributed I/O device.
Changes compared to the previous version
Compared with the previous version, this manual includes the following changes/additions:
• Updates in section Standards and certifications (Page 92)
Standards and certifications
You can find information on the standards and approvals that are fulfilled by the
ET 200eco PN distributed I/O device in the section Standards and certifications (Page 92).
Scope of information
In addition to this manual, you need:
• The manual for the IO Controller you are using
• The PROFINET System Description
(https://support.industry.siemens.com/cs/ww/en/view/19292127) system manual,
• The From PROFIBUS DP to PROFINET IO
(https://support.industry.siemens.com/cs/ww/en/view/19289930) programming manual.
• The IO-Link System (https://support.industry.siemens.com/cs/ww/en/view/65949252)
function manual.
4
Operating Instructions, 06/2022, A5E01250250-AN
ET 200eco PN