Terminal Block And Voltage Distributor; Terminal Block - Siemens SIMATIC Distributed I/O ET 200eco PN Operating Instructions Manual

Terminal block and voltage distributor

12.1

Terminal block

Article number
6ES7194-6CA00-0AA0
Properties
The terminal block has the following properties:
• The terminal block can be inserted and screw-mounted on any I/O device
• It can also be used separately.
• It distributes 10 A per supply voltage 1L+ and 2L+ to the I/O devices. You can tap a
maximum load of 4 A from each supply voltage of the I/O device. The voltages are
protected with two 7.5 A fuses.
Pin assignment
The tables below show the pin assignments.
Table 12-1 Pin assignment of the terminal block
Pin
1
2
3
4
Table 12-2 Pin assignment of the M12 connector
Pin
1
2
3
4
ET 200eco PN
Operating Instructions, 06/2022, A5E01250250-AN
Assignment
24 V (1L+ non-switched)
Ground 1M (non-switched)
24 V (2L+ switched)
Ground 2M (switched)
Assignment
24 V (1L+ non-switched)
Ground 2M (switched)
Ground 1M (non-switched)
24 V (2L+ switched)
View of the insulation displacement ter­
minal block:
View of the cable connector
12
221