Siemens SIMATIC Distributed I/O ET 200eco PN Operating Instructions Manual page 146

Technical data
• Between 1L+, channels and all other circuit ele­
ments
• Between channels
• Between Ethernet and all other circuit elements Yes
Status, interrupts, diagnostics
Interrupts
Diagnostics function
• Group error/maintenance
• Bus monitoring PROFINET IO
• Monitoring of supply voltage 1L+
• Existing connection to network
• Digital input
• Fault at digital input
• Digital output
• Fault at digital output
• Diagnostic information can be read
Monitoring for
• Failure of 1L+ and 2L+
• Sensor supply short-circuit
• Digital output short-circuit
• Digital input wire break
• Digital output wire break
Sensor supply
Number of sensor supplies
Load current
Short-circuit protection
Sensor selection data
Cable length, shielded
Cable length, unshielded
Input voltage
• Nominal value
• For signal "1"
• For signal "0"
Input current
• At signal "1"
ET 200eco PN
Operating Instructions, 06/2022, A5E01250250-AN
I/O device digital inputs/digital outputs
9.3 I/O device digital inputs/digital outputs
No
No
Yes
Yes
Red/yellow "SF/MT" LED
Red "BF" LED
Green "ON" LED
Green "P1 LK" and "P2 LK" LED; LED for PROFINET IO
infeed and loop-through
Green LED
Red LED
Green LED
Red LED
Yes
Yes
Yes, per channel
Yes, per channel
Yes, input current < 0.3 mA, per channel
Yes, in the off state, per channel
8, 4×1L+ and 4×2L+
Note: The sensor supply is only available when the
corresponding channel is parameterized as an
"Input".
100 mA per output
Yes, electronic
Max. 30 m
Max. 30 m
24 V DC
11 to 30 V
-3 to +5 V
Typ. 7 mA
147