Parameter - Siemens SIMATIC Distributed I/O ET 200eco PN Operating Instructions Manual

IO-Link Master
11.2 IO-Link Master (6ES7148-6JD00-0AB0)
When configuring IO-Link submodules, you can select address spaces for I/O data in the
following byte scales:
• 1 I/1 O + PQI
• 2 I + PQI
• 2 I/2 O + PQI
• 4 I/4 O + PQI
• 8 I/8 O + PQI
• 16 I/16 O + PQI
• 32 I/32 O + PQI
NOTE
Port Qualifier Information (PQI)
The Port Qualifier Information (PQI) with the size of 1 byte is always transferred together with
the input data of the IO-Link device. The PQI cannot be deactivated.
Additional information on the structure of the PQI byte is available in the appendix I/O
address space (Page 251).
Various parameters are available depending on the operating mode.
More information on the parameters is available in the chapter Parameter (Page 214).
11.2.2

Parameter

Port parameters for the IO-Link Master 4 IO-L 4×M12
The following tables show the parameters that you can set for each submodule (each port) of
the 4 IO-L 4×M12 IO-Link Master.
Table 11-6 Diagnostics
Parameters
Diag: Missing 2L+
Diag: Port
Hardware interrupt (device
notification)
The following table shows the port parameters for 4 IO-L 4×M12 the IO-Link Master with
firmware as of V1.1.
Parameter
Port configuration without
S7-PCT
Operating mode
* Only effective if you use the port mode "IO-Link Manual".
214
Range of values
• Disable
• Enable
• Disable
• Enable
• Disable
• Enable
Range of values
• Disable
• Enable
• IO-Link auto start
• IO-Link manual
Default setting
Disable
Disable
Disable
Default setting
Disable
IO-Link auto start
Operating Instructions, 06/2022, A5E01250250-AN
ET 200eco PN