Installing The Ln1000-V Router; Removing The Ln1000-V Mobile Secure Router; Figure 5: Ln1000-V Mobile Secure Router - Front Panel - Juniper LN1000-V Hardware Manual

LN1000-V Mobile Secure Router Hardware Guide
Installing the LN1000–V Router
Wedge lock
Guide rail
Related Topics
Removing the LN1000–V Mobile Secure Router
10
Figure 5: LN1000–V Mobile Secure Router — Front Panel
Status LED RJ-45 Connector for debug
To install the LN1000–V router in a VITA 46.0–compliant chassis:
Insert the router into the guide rails located on the front of the chassis.
1.
Slide the router forward until the connector on the router's back panel contacts the
2.
connector in the chassis.
Push in the injector/ejector latch on the right side of the router front panel to complete
3.
the installation. If your chassis is not equipped to utilize the injector/ejector latch to
assist in insertion, press the front surface of the LN1000-V router until its connector
is fully seated in the chassis.
Using the 3/32 Allen wrench, tighten the two wedge locks to a torque of 5 in-lb.
4.
CAUTION: The guide rails provide cooling to the conduction-cooled router. If you do
not properly tighten the wedge locks, the router can overheat and fail.
Before You Install the LN1000–V Router on page 9
Powering On the LN1000–V Mobile Secure Router on page 11
The LN1000-V router is hot-swappable; power can be left on while you remove or replace
a router module without damage to the router or backplane.
To remove the router from the chassis:
Using a 3/32 Allen wrench, loosen the two wedge locks on the front panel of the
1.
LN1000-V router.
Ejector latch Wedge lock
Copyright © 2010, Juniper Networks, Inc.
Guide rail