Reinstalling The Sfms; Figure 53: Reinstalling An Mcs - Juniper Internet Router M160 Hardware Manual

M160 Internet Router Hardware Guide
3.
4.
If there is a second MCS, repeat the procedure to reinstall it.

Figure 53: Reinstalling an MCS

Reinstalling the SFMs

The router can have an SFM in each of the slots labeled
SFM 3
SFM, follow this procedure (see Figure 54):
1.
2.
3.
4.
5.
6.
108
Reinstalling Components into the Chassis
Align the rear of the MCS with the guides inside the chassis and slide it
in completely.
Press the extractor clip at each end of the MCS inward.
S F M 0
S F M 1
M S C 0
R E 0
at the rear of the chassis, as shown in Figure 3. To reinstall an
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis. Make sure the router
is attached to a proper earth ground. For more information about ESD, see
"Preventing Electrostatic Discharge Damage" on page 226.
Verify that the ends of the ejector handles are pulled outward to a position
nearly perpendicular to the faceplate of the SFM.
Place one hand under the SFM to support it and grasp one of the ejector
handles at the front with the other hand.
Align the rear of the SFM with the guides inside the chassis and slide it
in completely.
Press the ejector handle at each end of the SFM inward.
Tighten the thumbscrew on each ejector locking tab (shown in Figure 8) to
seat the SFM firmly in the chassis.
P C G 0
Extractor clip
SFM 0
through