3. Plug the terminal block into the relay contact, and use a 2.5-mm flat-blade screwdriver to tighten the
screws on the face of the block.
4. Attach the other end of the wires to the external device.
To attach a reporting device for the other kind of alarm, repeat the procedure.
Figure 60: Alarm Relay Contacts
Connecting the EX9200 to the Network
IN THIS SECTION
Install a Transceiver | 190
Connect a Fiber-Optic Cable | 193
Install a Transceiver
Before you install a transceiver in a device, ensure that you have taken the necessary precautions for
safe handling of lasers (see
Ensure that you have a rubber safety cap available to cover the transceiver.
The transceivers for Juniper Networks devices are hot-removable and hot-insertable field-replaceable
units (FRUs). You can remove and replace them without powering off the device or disrupting the device
functions.
Laser and LED Safety Guidelines and Warnings
).
190