110
Connecting the QFX5120 to External Devices
IN THIS SECTION
Connecting a Device to a Network for Out-of-Band Management | 110
Connecting a Device to a Management Console by Using an RJ-45 Connector | 111
Connecting a Device to a Network for Out-of-Band Management
You can monitor and manage these devices by using a dedicated management channel. Each device has
a management port to which you can connect an Ethernet cable with an RJ-45 connector. Use the
management port to connect the device to the management device.
Ensure that you have an Ethernet cable that has an RJ-45 connector at either end.
Figure 54 on page 110
shows the RJ-45 connector of the Ethernet cable supplied with the device.
Figure 54: RJ-45 Connector on an Ethernet Cable
To connect a device to a network for out-of-band management (see
Figure 55 on page
111):
1. Connect one end of the Ethernet cable to the management port (labeled MGMT or ETHERNET) on
the device.
2. Connect the other end of the Ethernet cable to the management device.