Wiring - Delta Electronics AH500 Manual


AH05PM-5A
1 05PM
2 RU N
ERR OR
3
S/ S
X0. 0
X0. 1
X0. 8
X0. 9
X0. 12
X0. 13
Y0.0+
-
Y0.0
5
Y0.1+
-
Y0.1
Y0.2+
-
Y0.2
Y0.3+
-
Y0.3
Y0.8
Y0.9
CO M
Number Name
1 Model name
RUN LED indicator
2
(green)
ERROR LED
3
indicator (red)
4 USB port
5 Terminals
Arrangement of the
6 input/output
terminals
7 Extension port
8 Label
9 Set screw
10 Connector
11 Projection

2.2 Wiring

An AH500 series motion control module is an open-type device. It has to be installed in a control box
which is free from dust, moisture, and shock/vibration. In order to prevent people who are not
maintenance men from operating the device, protective measures are required (e.g. Users need a
special tool or a key to open the control box).
An AC power supply can not be connected to input/output terminals, otherwise the device will be
seriously damaged. Before users power the device, they have to check the wiring of the power
supply. In order to increase the immunity against noise, the ground terminal
be grounded correctly.
C h ap te r 2 H a r dw ar e Sp eci f ica t io ns an d W ir in g
7
4
6
Model name of the module
Operating status of the module
ON: The module is running.
OFF: The module stops running.
Error status of the module
Blink: The module is abnormal.
Providing the mini USB communication interface
Input/Output terminals
Arrangement of the terminals
Updating the firmware
Nameplate
Fixing the module
Connecting the module and a backplane
Fixing the module
10
8
Description
9
11
on the device must
2 - 1 9