Delta Electronics AH500 Manual page 428

2. Value of the CycleStop input pin
Input value
True/False Stopping a whole cycle
3. Value of the InCam output pin
Output value
The slave axis specified
True/False meshes with the master
4. Stopping electronic cam motion by means of the CamOut input pin
If the CamOut input pin is set to True when the Enable input pin is True, the slave axis specified
will not mesh with the master axis specified, and the InCam output pin will be set to False. If the
CamOut input pin is reset to False, the lave axis specified will mesh with the master axis
specified, and the InCam output pin will be set to True.
Displacement of
the slav e axis
Starting an
electronic cam
operating cy clicall y
( E nable input pin)
Not meshing with the
master axis specified
(
CamO ut input pin)
T he slave axis specified
meshes with the master
axis speci fied.
(
InCam o utpu t p in )
5. Stopping electronic cam motion by means of the Enable input pin
If the Enable input pin is set to True, the slave axis specified will mesh with the master axis
specified. If the Enable input pin is reset to OFF, the slave axis specified will not mesh with the
master axis specified, and the InCam output pin will be set to False. If the Enable input pin is set
to True again, the slave axis specified will mesh with the master axis specified.
D isplacement of
the slav e axis
Starting an
electronic cam
operating cy clicall y
( E nable input pin)
T he slave axis specified
meshes wi th the master
axis specified.
(
InCam o utpu t p in )
If the Enable input pin is set to True, the slave axis specified will mesh with the master axis
specified. If the Enable input pin is set to False after the CycleStop input pin is set to True, cam
motion stops when a cycle is complete, and the InCam output pin is False when the cam motion
stops. If the Enable input pin is set to True again, the slave axis specified will mesh with the
master axis specified.
Definition
If the CycleStop input pin is set to True when the
Enable input pin is reset, cam motion will not stop
until a cycle is complete.
Definition
If the slave axis specified meshes with the
master axis specified, the InCam output pin
axis specified. will be set to True
Ch ap te r 8 El ec tro nic Ca m
Description
Description
Position of
the master axis
Position of
the master axis
8 - 9