Program Backup And Restoration; Backup - Delta Electronics AH500 Manual

Motion control module

Hide thumbs Also See for AH500:

Table of Contents

 To restore, set bit 13 in SR214 to 0.

 To backup devices, set bit15 in SR214 to 1.

For example, if the value in SR214 is 8000H, the file \AHMotion\Device\0.csv in a memory card will

be restored to the motion control module.

13.5 Program Backup and Restoration

The operation for a program backup is described below,

1. Monitor an AH500 series motion control module by PMSoft, and stop the operation under the

monitoring. Alternatively, set SM072 to 0 to stop O100.

2. Set SR214 by a device monitoring table or external communication.

 Set bit 12~bit 0 in SR214 to bit 0. The values of bit 12~bit 0 in SR214 represent a backup

 To backup, set bit 13 in SR214 to 1.

 To backup the program in the AH500 series motion control module, set bit 14 in SR214 to 1.

After the program backup is completed, a .raw file which includes the password for the backup

program will be generated in \AHMotion\Program\ in a memory card. The table above shows that

the name of the .raw file is 0.raw.

Ch ap te r 13 Expa nsio n Storage De vice

Table of Contents