Ethertalk; Preparations; Configuration Procedure; Overview - Xerox 4112 System Administration Manual

EtherTalk

Preparations

Configuration procedure

X er o x 4 112 /4 1 27 C o pi e r /P r i n te r S y s t em A d m i ni s tr at i on G u i d e
The following item is required when using an EtherTalk network:
• A network environment where EtherTalk can be used.

Overview

The machine can be connected to computers using an EtherTalk
network.
The following is the procedure to connect the machine to
EtherTalk network:
• Configuration on the Machine: Set up EtherTalk on the
machine.
• Configuration on the Computer: Install the print driver.

Configuration on the machine (EtherTalk)

This section describes the configuration procedure to connect the
machine to EtherTalk network.
Enable the EtherTalk port
NOTE 1: The configuration can also be performed using
CentreWare Internet Services or CentreWare Utilities.
NOTE 2: Enable the SOAP port and the SNMP port in most cases.
Refer to "Using CentreWare Internet Services" on page 3-1.
Enter the System Administrator Mode (Chapter 1 Entering the
1.
System Administrator Mode on page 1-15.)
Enable the EtherTalk port.
2.
a. Select System Settings.
b. Select Connectivity & Network Setup.
c. Select Port Settings.
d. Select EtherTalk and then select Change Settings.
e. Select Port Status and select Change Settings.
f. Select Enable and then select Save.
If necessary, set the IP Address (Chapter 1 Setting the IP
3.
address. on page 1-17).
2. Co n fi g ur a ti o n
2-9