Table of Contents
Advertisement
(13) Install the Guide channel (BASIC) in the Basic storage system and in the first extension console
with two screws (PWH4 x 8). Install the Guide channel so that the reference holes on part A
face toward the Basic storage system.
n
Be careful not to pinch the harness beneath the Guide channel (Basic).
Extension console
(14) Install the Guide channels (4) in the subsequent extension consoles with two screws (PWH4 x
8) respectively.
Install the Guide channel so that the reference holes on part A face toward the Basic storage system.
(15) Check that the connection of the Runner flex around the X cable is not disconnected or loose at
any position. Then rotate the X cable bracket (CBL-F) in the direction of the arrow A in the
guide channel (EX3). Insert the protrusions into the two slits. Slant it in the direction of the
arrow B so that the hole B of the X cable bracket (CBL-F) is aligned with the reference pin.
n
Be careful not to twist the X cable or the Runner flex when rotating the X cable bracket (CBL-
F). If it is twisted connection of the Runner flex may be disconnected.
Pay similar attention in the subsequent operations as well.
B
Reference
pin
Hole B
CSM-200
screw
X rail
X belt
Basic storage system
Guide channel (4)
screw
X rail
X belt
Rear door side
Guide channel (EX3)
Guide channel (EX3)
A
X cable bracket
(CBL-F)
Guide channel (Basic)
portion A
screw
screw
portion A
Basic storage
system side
X cable
Runner flex
4-43
Advertisement
Table of Contents
