Table of Contents
Advertisement
When Expanding the extension consoles in the Range of 2 to 7 Extension Consoles
m
. When expanding two or more consoles, the Basic storage system must satisfy the conditions specified
in "Installing the Basic storage system (Installing the Basic storage system when expanding the
extension consoles in the range of 2 to 7 extension consoles)" in Section 4-2-3.
. Before connecting two extension consoles, perform steps (1) to (3) of "12. Connecting the X Rail (top)"
to loosen bolts and nuts, and then perform step (1) of "13. Connecting the X Rail (bottom)" to loosen
bolts to allow the X rails to slide.
5. Expand the first extension console to the Basic storage system.
(1) Adjust height of the four casters of the extension console until the two reference pins of the
extension console match the reference holes of the Basic storage system. Then, expand the
extension console to the Basic storage system while aligning the two reference pins of the
extension console with the corresponding reference holes of the Basic storage system.
n
One full clockwise rotation of a caster by 360d raises the console by 2.5 mm. Counter-clockwise
rotation of a caster by 360d lowers the console by 2.5 mm.
(2) If there exists a clearance between the contacting surfaces of the Basic storage system and that
of the extension console, fine-adjust height of the four casters until the clearance is removed.
Allen wrench (10 mm)
Loosen
here.
Caster
4-22
Basic storage system
Extension console
Reference
pin
Casters
M20
N20
Reference
hole
Reference
hole
Reference pin
Casters
CSM-200
Advertisement
Table of Contents
