Table of Contents
Advertisement
(6) Install the first drive reflector plate base so that the reflector plate faces toward the rear side.
The reflector plate of the first drive reflector plate base must be installed in the way that the protruded
portions a, b and c of the first drive reflector plate base enter the corresponding slits, and that the two
dowels are aligned with the corresponding holes so that the positioning is correctly is set. After the
correct positioning is obtained, secure it with the screw as shown.
n
Confirm that the two bosses fit into the holes and the drive reflector plate base is in close contact with
the fixing table.
When a number plate is attached to the drive reflector plate, it indicates that the installation position
of the drive reflector plate is already determined. Install the drive reflector plate in the specified
position by referring to the illustration.
a
Drive
reflector
plate base
(type1)
Dowel
(7) Install the second drive reflector base following the same procedure as described in step (6).
CSM-200
b
c
Reflector plate
PWH4 x 8
Drive reflector plate installation
position indication
5
6
5
6
3
4
3
4
1
2
Number plate
1
2
4-119
Advertisement
Table of Contents
