Table of Contents
Advertisement
[When the drive reflector plate base type 1 is used]
Drive reflector plate base (Type1)
(4) Remove the two screws. Remove the first drive reflector plate base in the direction of the arrow. To
remove the first drive reflector plate base, remove it in the way of removing the two protruded
portions in the top of the first drive reflector plate base, from the slits as shown.
(5) Remove the second drive reflector plate base in the same procedure as step (4).
Slit
Drive reflector
plate base
(type1)
4-118
Projection
PWH
4 x 8
CSM-200
Advertisement
Table of Contents
