Table of Contents
Advertisement
(3) Return the phase adjustment pins to their original positions.
Tightening torque: 0.8 N.m (8 kgf.cm)
n
Be sure to return the phase adjustment pins to their original positions upon completion of the
phase adjustment.
19. Movement check of X belt
Hold the Y rail, and check the followings during its right and left movements in the X direction.
. Confirm that the X cable is in parallel with the X rail. If the X cable is not parallel, lift up the X
cable gently several times so that it becomes parallel.
. Confirm that the transfer assembly can move along the X rail from an end to another end.
20. Setting the Console
(1) Remove the front inner panel. (Refer to "4-2-1. Opening the Outer Cabinets".)
(2) Change and confirm the settings of the switch (S101) on the SE-716 board of the Basic storage
system and of the extension console. (Refer to "4-4. Switch Setting".)
(3) Install the front inner panel by reversing the steps of removal.
CSM-200
4-39
Advertisement
Table of Contents
