Table of Contents
Advertisement
(5) Attach the rear bracket to the main unit of the attachment. Be sure that the harnesses are not
caught in between.
1 Connect one end of the supplied FC relay harness to the tape drive.
2 Connect the other end of the harness to the FC relay adaptor on the rear bracket from the
inside.
3 Attach the rear bracket, using the three screws you removed in step (2).
m
. Draw the FC relay harness so that the bending radius is more than 30 mm.
. Clamp the harness together with the power and communication harnesses to prevent slack near
the fan, as shown below:
to the FC relay adaptor
(inside the bracket)
3. Installing the drive unit
Install the assembled drive unit to the optional drive slot in the drive area of the PetaSite S200 series.
The installation procedure is the same as that of the S-AIT drive. Refer to the installation procedure
in "In the Case of the S-AIT Drive".
4-116
1
FC relay harness
2
FC relay adaptor
(outside)
3
Rear bracket
CSM-200
Advertisement
Table of Contents
