Table of Contents
Advertisement
4-2-3. Installing the Basic Storage System
The following description applies when installing the Basic storage system only or when
installing a single extension console only.
Determining the installation location
Determine the installation location and move the Basic storage system.
n
Free space allowing to open/close the door is necessary during inspection or maintenance.
(Refer to 4-1-1. "Installation Space".)
Determine the installation location taking the free space into consideration.
Fixing the Basic storage system
1. Open the front door and the rear door. (Refer to 4-2-1. "Opening the Outer Cabinets".)
2. Rotate the adjuster foot by hand until the feet of the Basic storage system contact the floor, and
completely ground them on the floor.
3. Install tentatively the washers and hexagon nuts (20) that are supplied with the extension console, in
the screwed portions of the four adjuster feet. (Tighten them at the four positions.)
4. Rotate the four adjuster feet by 180d in the direction of the arrow using an open-end wrench.
5. Tighten finally the four hexagon nuts (20) with the four washers that are tentatively tightened in step
3.
CSM-200
Hexagon nut (20)
Washer
Hexagonal bolt
block
Adjuster foot
4-13
Advertisement
Table of Contents
