Table of Contents
Advertisement
18. Phase Adjustment
(1) Move the transfer to the extension console side. Move the phase adjustment pin of the Basic
storage system to the adjustment position.
(2) Push the X slider (top) and the X slider (bottom) against the phase adjustment pin. Then, check
the clearances at the top and bottom satisfy the specification.
Specification: Clearance must be 0.1 mm or less.
If the clearance does not satisfy the specification, loosen the hexagonal head cap bolt (M5 x 12)
and perform the phase adjustment until the specification is satisfied.
X slider (bottom)
4-38
Specification: The thickness gauge of 0.1 mm cannot be entered.
X slider (top)
Specification: The thickness gauge of 0.1 mm cannot be entered.
Phase
adjustment pin
Top surface
Phase adjustment pin
Phase adjustment pin
Floor surface
CSM-200
Advertisement
Table of Contents
