Table of Contents
Advertisement
6-6.
Execute Mode Setup
(1) Select "Setup.." "PSC" from the pull-down menu, and select the "Execute mode" tag.
(2) Set Execute mode of each Bin Division and Others according to the application to use.
(3) Click [OK].
6-7.
Operation Check
(1) Check the network connection by PING and SNMP.
. Terminal Servers (for CC, Drive I/F)
. End-User LAN
(2) Check the connection between the library and the drive by MMT.
(3) Check the manual displacement of the cassettes by MMT.
(4) Check the displacement and operation of the cassettes performed by the user application.
Example) PetaBack
6-8.
Recording the System Setup Information
Click "LOG", and select "Get System Information" from the pull-down menu.
Save the setup information by printing the created sysinfo.txt or by copying the data.
n
For HP's Proliant DL360 G5/G6, no floppy disk can be used as an external medium. Use USB memory
(USB 2.0 or higher) instead.
However, check beforehand whether the USB memory can be used because there are some unavailable
USB memory devices. FAT format only is available.
In case you log into the root account, when the USB memory is inserted into the USB port of the unit, it is
automatically mounted.
Open the terminal window. When a mount path has been created in the "/media" directory on the window,
the USB memory can be used.
An example of Sony Poket Bit
/media/usbdisk/
To remove the USB memory, be sure to unmount it by entering as follows:
# unmount /media/xxx/
If you do not log into the root account, the USB memory is not automatically mounted. In this case, check
the device name (/dev/sdaN) of the USB memory using the "dmesg" command, and then mount it using
the "mount" command.
Example
# mount /dev/sda1 /mnt
To remove the USB memory, be sure to unmount it.
Do not reboot the system with the USB memory mounted. This may cause a problem with device recog-
nition.
4-106
CSM-200
Advertisement
Table of Contents
