Table of Contents
Advertisement
(13) Install the X belt holder bracket in the X slider (bottom) using the two hexagonal head cap bolts
(M5 x 12).
16. Remove the X-axis shipping metal fixture and the Y-axis shipping metal fixture. (Refer to "4-2-2.
Removing the Shipping Metal Fixture".)
17. Confirm the X belt tension as follows.
Measuring method using the acoustic-type belt tension gauge (J-2614-010-A)
(Recommended procedure)
Set the belt tension in the front (rear door side) of the belt using the acoustic-type belt tension gauge
as shown below.
(1) Move the transfer unit to the tension measuring position (400 mm) as specified.
(2) Run the transfer unit to the right and left by approximately 100 mm to remove non-uniformity of
belt tension.
(3) Return the transfer unit back to the position specified in the illustration.
(4) Use the acoustic-type belt tension gauge (J-2614-010-A) in the subsequent steps in accordance
with the Operation Manual supplied.
Set the following values in the acoustic-type belt tension gauge.
WEIGHT (M): 3.5 g/m
WIDTH (W):
15.0 mm
SPAN (S):
400 mm
(5) Set the tension gauge in the MEASURE mode. Bring the tension gauge close to the center of the
distance 400 mm of the belt from the rear door side in the right angle with the belt. Strike the
measuring position of the belt with finger, and measure the belt tension (unit: N).
Specification: F = in the range of 100 to 130 N.
(6) In the case of NG, adjust the belt tension again using the adjusting screw of the X tension
assembly, and repeat the procedure after step (2).
4-36
M5 x 12
Washer (D5)
X belt holder bracket
X slider (bottom)
X belt holder bracket
X rail
X belt
Transfer
assembly
400 mm
Acoustic-type belt
Tension gauge
CSM-200
Advertisement
Table of Contents
