Table of Contents
Advertisement
(6) Loosen the three hexagon socket bolts (M4 x 14) that are secured in step (4), to the extent that
the X pulley-fixing table can be moved to the right and left.
Tighten the adjustment screw until the stepped portion of the tension adjustment shaft is aligned
with the end surface of the X pulley assembly. Then tighten the three hexagon head cap bolts
(M4 x 14).
Tighten the three hexagon socket bolts (M4 x 14).
Tightening torque Specification: 2.5 N.m (25 kgf.cm)
(7) Install the X belt holder bracket in the X slider (top) using the two hexagonal head cap bolts (M5
x 12).
n
The hexagonal head cap bolts must be positioned in the center of the long holes.
4-34
X pulley assembly
M4 x 14
M4 x 14
Align here
X belt holder bracket
Washer
(5.5 x 16 x 1.5)
X slider (top)
M5 x 12
Adjustment screw
CSM-200
Advertisement
Table of Contents
