Table of Contents
Advertisement
(8) Confirm that the X belt (bottom) is not twisted. Engage the six teeth of an end of the belt with
the six teeth of the other end of the belt in between the X belt holder bracket and the X belt
holder that are removed in step (10) of "14. Removing the X Belt". Connect the belt using the
six hexagon socket bolts (M3 x 12), six spring washers and six washers.
(9) Install the washer (4.5 x 15 x 1.5) and the hexagon head cap bolt (M4 x 14) (a) removed in step
(10) of "14. Removing the X Belt" at the same positions of the end console.
(10) Install the X belt (bottom) around the lower pulley of the synchro shaft. Secure the X pulley
assembly (bottom) using the two hexagonal head cap bolts (M4 x 14) (b) and the two washers
(4.5 x 15 x 1.5), to fix it to the end console (the console that is lastly installed).
n
Tighten the hexagonal head cap bolts (M4 x 14) (b) while pulling the X pulley assembly
(bottom) in the direction of increasing the belt tension.
Adjust the engagement between the X belt and the synchro shaft pulley so that the X belt holder
bracket is positioned within the range enabling the installation of the X slider (bottom).
(11) Rotate the hexagonal head cap bolt (c) of the X tension assembly, that is removed in step (8) of
"14. Removing the X Belt", fully in the direction of loosening the spring. Then install it in the
end console (the console that is attached last) by reversing the steps of removal.
(12) Loosen the two hexagonal head cap bolts (b) (M4 x 14) that are tightened in step (10). Then,
tighten the adjustment screw until the stepped portion of the tension adjustment shaft is aligned
with the end surface of the X pulley assembly. After they are aligned, tighten the three hexago-
nal head cap bolts (M4 x 14) (a), (b).
(a) M4 x 14
CSM-200
Six gear teeth Six gear teeth
X belt
(b) M4 x 14
(b) M4 x 14
X pulley
assembly (bottom)
Washer
(4.5 x 15 x 1.5)
X belt holder
X belt holder bracket
Washer (4.5 x 15 x 1.5)
(d) M4 x 8
(c) M4 x 25
X tension
assembly
4-35
Advertisement
Table of Contents
