Setting Up/Storing The Printer; Setting Up; Storing The Printer - Epson SC-F9200 Series Service Manual

SC-F9200 Series

5.2 Setting Up/Storing the Printer

5.2.1 Setting Up

Make sure to open up the following installation room for the printer so as to maintain
appropriate operation and usability.
Figure 5-1. Installation Room Requirement
MAINTENANCE

5.2.2 Storing the Printer

When storing the printer, make sure to leave the Ink Tank installed and place it on a
horizontal surface, and also inform the user on the following cautions.
 When not using the printer for a long time

Turn on the printer at least once a week to let it clean the nozzles and prevent
clogging of the nozzles.

Remove the media. If the media is left set for a long time, nip impression of
the Press Roller may remain on the media, or the media may ripple.

Check that the Printhead is capped properly.

Close all the covers.

When storing the printer for a long time, evacuate the ink and flush the ink
passage. (See
 Before using the printer again
Make sure to print a nozzle check pattern and check for clogging of the printhead.
If any clogging can be seen, carry out a head cleaning.
C H E C K
After performing the head cleaning a few times, try turning off the
P O I N T
printer and leaving it overnight or longer, so that the ink may
dissolve and the clogging might be improved.
Setting Up/Storing the Printer
"4.12.5 Tube Inner Cleaning" (p333).)
SE Group Confidential (Related Staff Only)
Revision B
367