Epson SC-F9200 Series Service Manual page 26

SC-F9200 Series
Menu
Media Setup Customize Settings
PRODUCT DESCRIPTION
Table 1-17.
Menu Item/Setting Values (shaded one is the default)
Heating & Drying
Media Suction
Head Movement
1 to 30
(Media setting bank)
Multi-Strike Printing
Roll Type
Tension
Measurement
Setup Menu
Mode 0
Mode 1
Blank Area Feed
Mode 2
Mode 3
0 to 10
Data Width
Printer Full Width
OFF
2 to 8
Printable Side Out
Printable Side In
Periodically
Every Page
Control Panel
Explanation
If there is a section without print data (a blank area) during a
job, the media is fed quickly. If the value for the selected mode
is small, the media is fed at a quicker speed. If this mode does
not allow the ink to dry sufficiently, see the following section
and change the mode.
Set it to a suction level appropriate for the used media.
Choose the range in which the print head moves during printing.
[Data Width] restricts print head movement to the printed area.
Restricting the extent of print head movement increases print
speed.
If [Data Width] is selected, the print head will move the full
width of the largest media supported by the printer. Select this
option for more even print results with less variation.
Choose the number of times each line is printed.
Choose [Printable Side Out] or [Printable Side In] according to
how the media is rolled.
Choose [Periodically] or [Every page] to have the printer
automatically monitor and adjust media tension during printing
for optimal results, [Off] to disable automatic tension
adjustment. [Periodically] is recommended in most
circumstances.
Select [Every page] for more precise tensioning, but note that
print times will increase.
SE Group Confidential (Related Staff Only)
Revision C
26