Epson SC-F9200 Series Service Manual page 364

SC-F9200 Series
 AH Position Adjustment
C H E C K The following procedure is described for the case of -3 mm
P O I N T
deformation.
1. Loosen the adjustment nut of the adjuster on the home side.
2. Rotate the adjustment nut until the adjuster is aligned according to the amount of
deformation.
Home side
Adjustment nut
Adjuster
Figure 4-90. AH Position Adjustment (1)
3. Secure the adjuster with the nut.
Home side
Figure 4-91. AH Position Adjustment (2)
ADJUSTMENT
One turn of the adjuster raises/lowers
the After Heater by approximately 1.2
mm.
After Heater
Adjuster
Nut
Other Printer Checks and Adjustments
4. Loosen the adjustment nut of the adjuster on the full side.
5. Rotate the adjustment nut until the adjuster comes in contact with the printer.
6. Secure the adjuster with the nut.
Full side
Adjustment nut
Nut
Figure 4-92. AH Position Adjustment (3)
SE Group Confidential (Related Staff Only)
Revision C
Adjuster
Printer
364