Epson SC-F9200 Series Service Manual page 211

SC-F9200 Series
3.4.6.2 Media Loading Lever Sensor
1. Move the Media Loading Lever to the rear side, and set it to the release position.
2. Disconnect the connector of the Reel Unit.
3. Remove the five screws, and remove the Right Rear Cover.
A) Silver M4x10 S-tite screw with washer: 4 pcs
B) Silver M3x6 screw: 1 pcs
A
B
Reel Unit
Connector
A
Figure 3-157. Removing the Right Rear Cover
DISASSEMBLY & ASSEMBLY
Right Rear Cover
A
A
Disassembly and Assembly Procedure
4. Remove the six screws that secure the Rear Cover.
C) Silver M3x8 S-tite screw with built-in washer: 6 pcs
C
C
Figure 3-158. Removing the Rear Cover
5. Disconnect the connector from the Media Loading Lever Sensor.
Connector
Media Loading Lever Sensor
Figure 3-159. Connector of the Media Loading Lever Sensor
SE Group Confidential (Related Staff Only)
Revision B
Rear Cover
C
C
C
C
Be careful of
C A U T I O N
the direction
of connector.
upper
lower
211