Epson SC-F9200 Series Service Manual page 30

SC-F9200 Series
Menu
Side Margin (Right)
Side Margin (Left)
Printer Setup
Print Start Position
Margin Between Pages
Media Size Check
PRODUCT DESCRIPTION
Table 1-17.
Menu Item/Setting Values (shaded one is the default)
3 to 25 mm (0.12 to 1.00inch)
3 to 25 mm (0.12 to 1.00inch)
0 to 800 mm (0.00 to 32.00 inch)
Normal
No Margin -10 mm to +10 mm
ON
OFF
Control Panel
Setup Menu
Sets the side margin from the media's right end while the media
is set in the printer. The media's right end differs depending on
[Media End Check] setting in the Setup Menu as follows.
When Media End Check is On: Right end of the media
When Media End Check is Off: Right end standard position (the
position up to Platen through the center of the media set position
attached on the Pre Heater)
Sets the side margin from the media left end while the media is
set in the printer. The media left end differs depending on
[Media End Check] setting in the Setup Menu as follows.
When Media End Check is On: Left end of the media
When Media End Check is Off: The position to the left 64 inch
from the right end standard position
Adjust this parameter if you want to print from the near center
of the media or if you want to shift the printed area left from the
Side Margin (Right) setting. The area between the right edge of
the media and Print Start Position is left blank. If a value is
selected for Side Margin (Right), an additional area
corresponding to the width selected for Side Margin (Right) will
be left blank. See the following for more information.
---
Allows you to enter a margin between pages. Even after making
adjustments, the size of the margin may change depending on
the media and usage environment. The margin increases when
the number is moved in the + direction, and decreases when the
number is moved in the - direction.
Selects [On] to detect the media width and the top or [Off] to set
it to off. Select [Off] and print when Media Size error is
displayed even though the media is set correctly. However,
when this setting is set to [Off], the printed data can be out of
range of the media. If it happens, the ink contaminates the inside
of the printer. Setting to [On] is recommended usually.
Explanation
SE Group Confidential (Related Staff Only)
Revision C
30