Epson SC-F9200 Series Service Manual page 348
Large format color inkjet printer
Hide thumbs
Also See for SC-F9200 Series:
- User manual (144 pages) ,
- Setup manual (81 pages) ,
- Setup manual (36 pages)
Table of Contents
Advertisement
SC-F9200 Series
Figure 4-71. Pop-up message
Color which is displayed "OK": Complete the procedure. If all colors are
"OK", turn the printer OFF to finish the adjustment
Color which is displayed "NG": perform the following steps.
5.
Refill Ink from a new ink pack until becoming full capacity of the Ink Tank.
6.
Install the chip unit which is attached the new ink pack.
7.
Inform customer to keep use ink without Reservation until the amount of ink in
Ink Tank is less than 70mm from the base of the Ink Tank .
(Once the amount of ink in Ink Tank is less than 70mm, Reservation works as
usual.)
8.
To inform customer which color couldn't be restored, put circle mark at
next page.
9.
Turn the printer OFF to finish the adjustment.
ADJUSTMENT
Step2
on
Boards Related Checks and Adjustments
SE Group Confidential (Related Staff Only)
Revision C
348
Advertisement
Table of Contents
Troubleshooting
