Epson SC-F9200 Series Service Manual page 53

SC-F9200 Series
Code Error Name

Connection failure of the ATC Motor.

The ATC Motor was driven at a speed abnormally
slower than a predetermined one during operation.
ATC Motor
159F

Irregular load
lock error

ATC Motor encoder failure

ATC Motor failure
Roll/Reel Units The combination of the Roll Unit and Reel Unit may
1610
mismatch error be wrong; one of the units may be an optional unit.
Roll Unit The Roll Unit could not be detected during
1611
undetectable error mechanism initialization process.
Roll Unit When the ATC Motor started to operate, it was
1612 undetectable error at detected that the Roll Unit status is different from that
the start of operation detected during mechanism initialization process.
Roll Unit
The connector of the Roll Unit was disconnected
1613 undetectable error
during the ATC Motor was operating.
during operation
Reel Unit When the Reel Motor started to operate, it was
undetectable error at detected that the Reel Unit status is different from that
1614
the start of operation detected during mechanism initialization process.
Reel Unit
The connector of the Reel Unit was disconnected
1615 undetectable error
during the Reel Motor was operating.
during operation
There is a problem with a specific bit on the board,
Roll Unit Board failure
1616
which detects what device is connected to the board.
There is a problem with a specific bit on the board,
Reel Unit Board failure
1617
which detects what device is connected to the board.
Roll/Reel Unit Board There is a problem with a specific bit on the board,
1618
failure which detects what device is connected to the board.
TROUBLE SHOOTING
Table 2-4. Troubleshooting for Service Call Error
Cause
1. Is there any problems such as damaged cable in the
connections below?

ATC Motor to Sub-F Board (CN602)
2. Does the ATC Motor encoder work properly?
Check it using the Service Program.
Is the combination of the Roll Unit and Reel Unit
either both of them are standard units or both of them
are optional units?
Is the connector of the Roll Unit disconnected?
1. Is the connector of the Roll Unit disconnected?
2. Has the Roll Unit been replaced since the power on
and while the ATC Motor was stopping?
Is the connector of the Roll Unit disconnected?
1. Is the connector of the Reel Unit disconnected?
2. Has the Reel Unit been replaced since the power on
and while the Reel Motor was stopping?
Is the connector of the Reel Unit disconnected?
Unexpected error
Unexpected error
Unexpected error
Remedies for Service Call Error
Check Item
Replace the ATC Motor.
Correct the combination of the Roll Unit and Reel
Unit to either both are standard or both are optional.
Connect the connector of the Roll Unit.
1. Connect the connector of the Roll Unit.
2. Turn the printer off and back on.
Connect the connector of the Roll Unit.
1. Connect the connector of the Reel Unit.
2. Turn the printer off and back on.
Connect the connector of the Reel Unit.
Replace the Sub-F Board of the Roll Unit.
239)
Replace the Sub-F Board of the Reel Unit.
247)
Replace the Sub-F Board of the Roll Unit
239)
and Reel Unit
SE Group Confidential (Related Staff Only)
Revision C
Remedy
(Page 241)
(Page
(Page
(Page
(Page 247)
.
53