Epson SC-F9200 Series Service Manual page 224

SC-F9200 Series
3.4.6.10 PE Sensor
When replacing/removing this part, refer to
A D J U S T M E N T
R E Q U I R E D
Items and the Order by Repaired Part" (p260)
perform the specified operations including required adjustment.
1. Remove the Loading Guide. (See
Support" (P. 227)
)
2. Remove the screw, and remove the PE Sensor Holder.
A) Silver M3x8 S-tite screw: 1 pcs
When removing/attaching the screw, be careful not to scratch the
C A U T I O N
FFC.
3. Slide the PE Sensor Holder in the direction of the arrow to disengage the two
hooks.
PE Sensor Holder
Figure 3-174. Removing the PE Sensor Holder
DISASSEMBLY & ASSEMBLY
"4.1.2 Adjustment
and make sure to
"3.4.6.12 PF Roller Center
Step 7 in
Hooks
A
Disassembly and Assembly Procedure
4. Remove the PE Sensor from the PE Sensor Holder, and disconnect the FFC.
FFC
PE Sensor
Figure 3-175. Removing the PE Sensor
The area around the PE Sensor is shaded with acetate tape. Make
sure to restore the tape you peeled when disassembling back to the
original condition.
SE Group Confidential (Related Staff Only)
Revision B
PE Sensor Holder
224