Epson SC-F9200 Series Service Manual page 113

SC-F9200 Series
3.4.3.9 Left Front Cover/L Maintenance Cover Sensor
(p110)
1. Remove the Left Rear Cover.
2. Remove the Left Upper Cover. (p111)
3. Remove the screw, and remove the L Maintenance Cover Sensor.
A) Silver M3x10 P-tite screw with washer: 1 pcs
C
B
Tabs
B
Figure 3-33. Left Front Cover/L Maintenance Cover Sensor Fixing Screws
DISASSEMBLY & ASSEMBLY
B
L Maintenance
A
Cover Sensor
B
B
Left Front Cover
Disassembly and Assembly Procedure
4. Remove the six screws that secure the Left Front Cover.
B) Silver M4x10 S-tite screw with washer: 5 pcs
C) Silver M4x12 P-tite screw with washer: 1 pcs
At the next step, be careful not to pull the Left Front Cover too
C A U T I O N
much as the cable of the L Maintenance Cover Sensor is connected
to the relay connector.
5. Slide the Left Front Cover toward the front of the printer.
6. Disconnect the cable of the L Maintenance Cover Sensor from the relay connector.

Insert the two tabs of the Left Front Cover into the two
positioning holes on the Left Cover.

Insert the two dowels of the frame into the two positioning
holes on the Left Front Cover.
Dowels
Relay Connector
Figure 3-34. Removing the Left Front Cover
SE Group Confidential (Related Staff Only)
Revision B
L Maintenance
Cover Sensor
113