Epson SC-F9200 Series Service Manual page 230

SC-F9200 Series
8. Remove the screw, and remove the PE sensor Holder Frame from main frame.
F) Silver M3x8 S-tite screw: 1pcs
When removing this part, refer to
A D J U S T M E N T
R E Q U I R E D
Order by Repaired Part" (p260)
specified operations including required adjustment.
Figure 3-182. Removing the PE sensor Holder Frame
DISASSEMBLY & ASSEMBLY
"4.1.2 Adjustment Items and the
and make sure to perform the
F
PE sensor Holder Frame
Disassembly and Assembly Procedure
9. Remove the two screws that secure the PF Roller Center Support using the ratchet
screwdriver.
G) Silver M3x8 S-tite screw: 2 pcs

Replace the PF Roller Center Support one by one. If you
C H E C K
P O I N T replace the five PF Roller Center Supports at once, the PF
Roller will warp.

To prevent the removed screw from dropping in the Suction
Fan, cover the fan with a sheet of paper.
Suction Fan
Attach the PF Roller Center Support as follows.
1. Insert the PF Roller Center Support into the space below the
PF Roller from the rear side while taking care not to damage
the PF Roller with the edge marked with a red circle.
Front
SE Group Confidential (Related Staff Only)
Revision B
Paper
PF Roller
PF Roller Center Support
230