Epson SC-F9200 Series Service Manual page 169

SC-F9200 Series
3.4.5.14 PG HP Sensor
(p98)
1. Unlock the CR Unit.
2. Remove the Wiper Cleaner. (p100)
3. Remove the Media Loading Lever.
4. Remove the Right Upper Cover.
(p108)
5. Remove the Right Cover.
(p110)
6. Remove the Left Rear Cover.
(p111)
7. Remove the Left Upper Cover.
(p114)
8. Remove the Left Cover.
(p167)
9. Remove the APG Unit.
(p161)
10. Remove the CR Motor.
(p139)
11. Remove the CR Cover.
(p140)
12. Remove the Duct CR.
(p144)
13. Remove the Print Head.
14. Remove the CR Scale. (p157)
(p200)
15. Remove the CR Unit.
16. Turn the PG gear until the slit of the incline plate faces the sensing portion of the
PG HP Sensor.
17. Disengage the hooks, and remove the PG HP Sensor.
18. Disconnect the cable from the PG HP Sensor.
DISASSEMBLY & ASSEMBLY
(p210)
(p103)
Disassembly and Assembly Procedure
- Back Side of the CR Unit -
Incline plate
PG HP Sensor
PG Gear
Figure 3-110. Removing the PG HP Sensor
SE Group Confidential (Related Staff Only)
Revision B
Cable
Hooks
169