Epson SC-F9200 Series Service Manual page 238

SC-F9200 Series
3.4.8.3 Roll Paper Holder
1. Remove the C-ring (φ25).
2. Remove the screw, and remove the plate.
A) Silver M3x8 P-tite screw: 1 pcs
3. Remove the screw that secures the Roll Paper Holder.
B) Special screw: 1 pcs
Before installing the Roll Paper Holder on the left, install the
holder and the spring as shown in the figure below.
- Left side -
Spring
When replaced with a new part, make sure to lubricate the new one
Lubrication Lubrication
referring to"5.6 Lubrication"
DISASSEMBLY & ASSEMBLY
Holder
(p387).
Disassembly and Assembly Procedure
Roll Paper Holder
C-ring
Roll Paper Holder
R Roll Unit
Figure 3-191. Removing the Roll Paper Holder
SE Group Confidential (Related Staff Only)
Revision B
Plate
A
B
L Roll Unit
238