Epson SC-F9200 Series Service Manual page 219

SC-F9200 Series
4. Insert a screwdriver from the rear of the printer and raise the Driven Roller Holder
to make the reassembly work easier.
5. Push the Driven Roller Assy in the direction of the arrow, and remove it from the
shaft bearing of the Driven Roller Holder.
Driven Roller Holder
Figure 3-170. Removing the Driven Roller Assy (2)
DISASSEMBLY & ASSEMBLY
Driven Roller Assy
PF Roller
Disassembly and Assembly Procedure

Install the Driven Roller Assy in the following procedure.
1. Move the Media Loading Lever to the rear side, and set it to the
release position.
2. Put paper at the position of remove (installing) Driven Roller
Assy.
3. Put the Driven Roller above Driven Roller Holder as following
picture.
Driven Roller Assy
Driven Roller
4. Move the Media Loading Lever to the front side, and set it to
the Hold position.
SE Group Confidential (Related Staff Only)
Revision B
1. Put the Driven
C A U T I O N
Roller to make
sure the interval of
rollers of it may
become even.
2. If the place of
Driven Roller Assy
is not steady,
please use tweezers
etc.
Driven Roller Holder
219