Epson SC-F9200 Series Service Manual page 235

SC-F9200 Series
3.4.7.2 Cooling Fan
(p233)
1. Remove the After Heater.
2. Remove the Heat Shield Assy. (p207)
(p106)
3. Remove the Lower Ink Holder.
4. Remove the Sub-E Board Cover. (See
133)
)
5. Disconnect the cable of the Cooling Fan from the connector (CN518) on the Sub-E
Board.
6. Release the cable of the Cooling Fan from the two clamps.
7. Insert the stubby screwdriver through the holes on the frame at the Cooling Fan
side to remove the two screws that secure the Cooling Fan, and remove the
Cooling Fan.
A) Silver M3x22 S-tite screw: 2 pcs
DISASSEMBLY & ASSEMBLY
"3.4.4.6 Sub-E Board" (P.
Step 2 in
Disassembly and Assembly Procedure
Clamps
CN518
Sub-E Board
Figure 3-188. Removing the Cooling Fan
SE Group Confidential (Related Staff Only)
Revision B
- Right side -
Holes
A
A
Cooling Fan
235