Activation Of Cleaning Cartridge - Epson SC-F9200 Series Service Manual

SC-F9200 Series

4.12.3 Activation of Cleaning Cartridge

EXECUTION MODE
Normal Mode
PROCEDURE
1. Turn the printer ON.
2. Take a picture of control panel. If you don't have camera, see the charge status and
reservation status on the control panel and write them down.(Refer to
4-52.)
C H E C K
If firmware has Charge & Reservation, and if you use the Cleaning
P O I N T
Cartridges, after performing Step3, Charge & Reservation will be
unavailable temporarily.
When returning to Ink tank, and when you select the Ink tanks
after performing Step3, Charge & Reservation will be available
again. Also, Charge status & Reservation status will return to the
original status. (before-cartridge-installation status.)
Take a picture of control panel or take a memo so that you can
check whether the charge status and reservation status are
returned originally.
3. Start the Service Program and select
4. Select from All channels or Single
select the Ink Holder to be validated
to be validated (C/Y or M/Bk).
5. Click [Run].
C H E C K
When switching to Ink Tanks from Ink Cartridges, Make sure
P O I N T
Charge status and Reservation status are returned to the original
status by comparing the picture or note which you wrote on Step2.
6. Turn off the printer.
ADJUSTMENT
Figure
Activation of Cleaning cartridges.
channel. When selecting Single channel, also
(Ink Holder 1 or Ink Holder 2) and the color
Ink Supply Related Checks and Adjustments
C H E C K
To make the settings effective, make sure to turn off the printer.
P O I N T
Figure 4-54. [Activation of Cleaning cartridges] Screen
SE Group Confidential (Related Staff Only)
Revision C
331